V.P. Koryachko1, D.A. Perepelkin2, V.Yu. Likuchev3

1,2 Ryazan State Radio Engineering University named after V.F. Utkin (Ryazan, Russia)
3 JSC «Ryazan Design Bureau «Globus» (Ryazan, Russia)
2 perepelkin.d.a@rsreu.ru, 3 v.likuchov@yandex.ru

In the context of the continuous increase in functional, structural, and technological complexity of electronic devices, there is a growing need for the use of automated design tools (hereinafter referred to as ADT) for electronic modules. These tools can significantly reduce the time required to perform standard design procedures. Currently, there is a noticeable lag between the functional capabilities of modern ADTs and the extensive theoretical developments in the field of mathematical support for such software. This discrepancy manifests itself in the low quality of optimization problem solutions produced by ADTs, thereby limiting their practical applicability. A primary source of information for the development of a unified approach to the creation and improvement of ADTs lies in the requirements for their functional composition, which are largely derived from the specifics of performing standard design procedures for electronic devices in practice.

The purpose of the work – to formulate general requirements for software tools of this kind based on an analysis of the functional composition of modern ADTs and the specifics of executing standard electronic module design procedures in practice.

An analysis was conducted of the ADTs integrated into modern electronic design automation systems. Based on this analysis, business requirements, functional and non-functional requirements, a use case list, and an activity model of the ADT were developed. An approach was proposed to address the most complex requirements for ADTs used in electronic module design. The results obtained in this study can serve as a foundation for the development of a unified methodological approach to the creation of effective ADTs for electronic modules intended for various applications.

Koryachko V.P., Perepelkin D.A., Likuchev V.Yu. Development and analysis of requirements for automated design tools for electronic modules. Dynamics of complex systems. 2025. V. 19. № 2. P. 12–20. DOI: https://doi.org/10.18127/j19997493-202502-03 [in Russian]

1. Kureychik V.M. Matematicheskoe obespechenie konstruktorskogo i tekhnologicheskogo proektirovaniya s primeneniem SAPR: Uchebnik dlya vuzov. M.: Radio i svyaz'. 1990. [in Russian]
2. Perepelkin D.A., Likuchev V.Yu. Mul'tiagentnyy podkhod avtomatizirovannogo proektirovaniya moduley radioelektronnykh ustroystv na osnove analiza inzhenernykh strategiy. V Mezhdunarodnyy nauchno-tekhnicheskiy forum STNO-2022. Sb. trudov. T. 3. [in Russian]
3. Sabunin A. Altium Designer Winter 09 – Razmeshchenie komponentov na plate i trassirovka pechatnykh provodnikov. Sovremennaya elektronika. M.: STA-PRESS. 2009. № 2. S. 38–47. [in Russian]
4. Koryachko V.P., Perepelkin D.A., Likuchev V.Yu. Matematicheskaya model' predstavleniya mul'tiagentnykh sistem i ee primenenie v zadachakh topologicheskogo proektirovaniya moduley radioelektronnykh sredstv. Vestnik Ryazanskogo gosudarstvennogo radiotekhnicheskogo universiteta. 2023. № 83. S. 48–61. DOI:10.21667/1995-4565-2023-83-48-61. [in Russian]
5. Bubnov A.A., Bubnov S.A., Maykov K.A. Razrabotka i analiz trebovaniy k programmnomu obespecheniyu: uchebnik. M.: KURS. 2025. [in Russian]